1 Spoolarc®
MIG Wires The wide
selection of MIG wires in the ESAB line insure that a wire with the proper amount
of deoxidizers is available
for whatever your requirements might be. Spoolarc
HI-DEP III wires have improved feedability because the wire surface is treated
with a special lubricant
which minimizes wire feed forces. Column strength is 25% greater than conventional
wires and the surface
copper is thin and tightly adherent — it won’t flake off.
Copper to copper (instead of copper-to-steel)
contact means far better current transfer, less arcing especially
at high currents resulting in longer contact tip life. Most
of the data in this booklet are based on AWS tests performed under laboratory
conditions. That is why it
is important to test the selected wire/gas combination in the same joint and under
the same conditions to be
used during actual production.
